Short Ram Intake System Installation Instructions of 2003-2004 Honda Accord 4-Cyl. 2.4L. Part of content: Before started the installation, make sure the vehicle is parked on a level surface. Then, set parking brake and install rear wheel chocks. Let the engine cool down. Jack the front of the vehicle and support using properly rated jack stands. And remove the left front wheel. The next steps is removal of the Stock Air Intake System.

How to remove Stock Air Intake System:
- Loosen the clamp around the throttle body using a 5.5mm socket or screwdriver. Pull the Intake Air Temperature (IAT) sensor out of the intake tube by loosening the spring loaded clamp.
- Unplug the breather tube from the fitting underneath the intake manifold
- Remove the air box mounting bolt shown in the picture.
- Remove the other air box mounting shown in the picture.
- Carefully remove the air box assembly from the engine bay.
- Remove the two fasteners holding the plastic cover in front of the battery.
- Pull upward on the plastic cover to remove the resonator box intake tube.
- From inside the driver-side wheel well, remove the fastener shown in the picture.
- From underneath the vehicle, remove the fasteners shown in the picture.
- Tuck the splash guard out of the way behind the brake rotor.