Panasonic TH-65PHD8UK, TH-65PHD8BK, TH-65PHD8EK Service Manual & Repair Guide

Automated PDF to Text preview page 4 to 6:

TH-65PHD8BK / TH-65PHD8EK / TH-65PHD8UK

15.58. SS-Board (2 of 2) Schematic Diagram 16 Parts Location 16.1. Exploded View 16.2. Cable relation 16.3. Packing summary

126 127 127 129 130

17 Mechanical Replacement Parts List 18 Replacement Parts List 18.1. Relpacement Parts List Notes 18.2. Electrical Replacement Parts List

133 134 134 135

4

TH-65PHD8BK / TH-65PHD8EK / TH-65PHD8UK

1 Applicable signals

5

TH-65PHD8BK / TH-65PHD8EK / TH-65PHD8UK

2 Safety Precautions
2.1. General Guidelines
1. When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. 2. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed. 3. After servicing, make the following leakage current checks to prevent the customer from being exposed to shock hazards.

2.1.1.

Leakage Current Cold Check

1. Unplug the AC cord and connect a jumper between the two prongs on the plug. 2. Measure the resistance value, with an ohmmeter, between the jumpered AC plug and each exposed metallic cabinet part on the equipment such as screwheads, connectors, control shafts, etc. When the exposed metallic part has a return path to the chassis, the reading should be between 1M and 5.2M. When the exposed metal does not have a return path to the chassis, the reading must be .

Figure 1

2.1.2.

Leakage Current Hot Check (See Figure 1 .)

1. Plug the AC cord directly into the AC outlet. Do not use an isolation transformer for this check. 2. Connect a 1.5k, 10 watts resistor, in parallel with a 0.15µF capacitors, between each exposed metallic part on the set and a good earth ground such as a water pipe, as shown in Figure 1 . 3. Use an AC voltmeter, with 1000 ohms/volt or more sensitivity, to measure the potential across the resistor. 4. Check each exposed metallic part, and measure the voltage at each point. 5. Reverse the AC plug in the AC outlet and repeat each of the above measurements. 6. The potential at any point should not exceed 0.75 volts RMS. A leakage current tester (Simpson Model 229 or equivalent) may be used to make the hot checks, leakage current must not exceed 1/2 milliamp. In case a measurement is outside of the limits specified, there is a possibility of a shock hazard, and the equipment should be repaired and rechecked before it is returned to the customer.

6