Xbox 360 3 Red Lights Error Repair Guide.pdf

Automated PDF to Text preview page 4 to 6:

Step Three: Find the gray plastic tabs by poking down into the holes, and then use your pry tool to very carefully push down and pry out the gray top/bottom cover, as shown below. Both pieces have three clips per side, and six per piece. In order to remove the top gray piece, you will need to remove the rubber pad. This is the only rubber pad you will have to remove. If you are careful you can remove by prying on the front of the gray cover. Please do not force it or you may break the tabs.

Step Four: Please take a close look at the back of the Xbox 360. On the right and left side there are small notches that will require a closer inspection. You will need a small screw driver or a remaining catches. This is probably the trickiest part of the whole process, so please take your time and be careful! thin probe tool. Using the probe, start on the left side (near power supply socket) push the notch into the Xbox until you hear a click. Then use a screw driver to keep the two sides apart. Once the left side is done, start on the right side doing the same thing to the

Step Five: Please switch around to the front of the Xbox and undo the four catches as shown below:

Once you have them all separated, pull off the bottom of the Xbox 360, be very gentle. Now, from the bottom of the Xbox 360 carefully flip the Xbox back over. Remove the DVD button arm assembly to keep it out of your way. You just need to gently pry it off the black plastic guide. Next, remove the top cover, watch the DVD button latch! (it is seated in the front metal casing) Disconnect the SATA connecter from the motherboard and lift the DVD drive out of the case. Step Six: Grab your Torx driver set. Using a T10 and T8 for this part of the disassembly. Gently unscrew the six T10 screws (as shown below), and then use the T10 to unscrew all other screws. Now, unscrew the black screws with the T8 driver. Not all Xbox 360's have the same color screws. You will have to remove all screws!

Step Seven:

You will now remove the white airflow guide. To remove the white plastic air guide, locate the notch on the top outward side. Insert your probe or small screw driver, and carefully pry the air guide out. It should come out very smoothly.

Step Eight: Next up you will need to disconnect the power for the cooling fans. Use your small screw driver or small probe tool to pry the fan catches out from the metal guard. This will allow you to remove the fan device from the Xbox 360 Casing.

Step 9 You will need to now look at the front of your Xbox 360 and locate the RF module. Remove the white plastic power cover. It pops right off by gently pulling