290 bookmarked indexed pages.
The Table of Contents pages show the page location
of various component groups on the machine.
When ordering service parts, specify the correct part
number, full description, quantity required, and the
unit model and serial number.
Model and serial numbers for this unit are stamped on
a plate located inside the operators station. The serial
number is also stamped on the top front of the
frame. The following reference shows the breakdown
of the serial number:
Right and left are determined from a position sitting
on the seat and facing forward.
GEHL Company reserves the right to make changes
or improvements in the design or construction of any
part of the unit without incurring the obligation to
install such changes on any unit previously delivered.
7 3 0 L J V 0 3 6 5 1 7 2
Year (T=02, U=03, V=04 etc.)
GEHL, Dynalift, Dynattach, Dynaline, Dynacarrier
and Dynahandler are registered trademarks of Gehl
Company. Bunker Buster and Agri-Loader are a
trademark of Gehl Company.
Size & Part No. Size & Part No.
#10-32 N L50050
1/4-20 NIN L520003
1/4 P L50137
1/4-20 SFN L50051
5/16 L L50143
5/16-18 N L50230
5/16-18 NIN L520004
5/16 P L50141
5/16-18 RNF L530004
5/16-18 SFN L50056
3/8-16 L L50147
3/8-16 N L50066
3/8-16 NIN L520005
3/8-16 P L50145
3/8-16 SFN L50061
3/8-16 WN L530003
7/16 L L50150
7/16-14 NIN L50517
7/16 P L50149
1/2-13 NIN L520019
1/2 P L50151
5/8 L L50156
5/8-11 N L50081
3/4-10 N L50086
3/4-10 NIN L50519
3/4 P L50147
1-8 JN L50145
TABLE OF STANDARD WASHERS, NUTS
Grease fittings and common attaching hardware, such
as cotter pins, set screws, woodruff keys, screws, nuts,
etc., are included in the parts list, indented below the
part it is (they are) associated with, but may NOT be
illustrated, except where a particular routing or special
fastening arrangement MUST be maintained. The
hardware listed is for mounting purposes and is NOT
included when the part is ordered for replacement.
Part numbers for standard hardware are listed indented
under the component being fastened.