Original Illustrated Factory Service Training Manual for Linde Forklift Truck 324 Series

Covered models:
E12
E15
E15S
E16S

Included Extra Manuals:
PULSE CONTROL IV FOR TRAVEL DRIVE IN LINDE FORK LIFT TRUCKS
PULSE CONTROL FOR WORKING HYDRAULICS LINDE E-FORK LIFT TRUCKS
REPAIR INSTRUCTION FOR ELECTRIC MOTORS

Included Chapters:

Technical Data for Electric Motors, Pumps and Fans
Traction Motors
Traction Motors 24 V (E 12/15) to 9/88
Traction Motors 24 V (E 12/15) from 10/88
Traction Motors 48 V (E 15 S/16 S]
Pump Motors
Pump Motor for Working Hydraulics, 24 V (12/15)
Pump Motor for Working Hydraulics, 48 V (E 15 S/16 S)
Pump Unit for Power Steering, 24 V (E 12/15)
Pump Unit for Power Steering 48 V (E 15 S/16 S)
Fans for Traction Motors

Wiring Diagrams for E 12/15/15 S/16 S, Type 324
Wiring Diagram (Standard) to 12/88
Wiring Diagram (Optional Equipment) to 12/88
Wiring Diagram (Standard.) from 1/89
Wiring Diagram (Optional Equipment) from 1/89
Control Circuit
Connector LI (E 12/15/15 S/16 S)
Connector L4 (E 12/15) for Timer
Pin Arrangement L4
Pin Arrangement L4 (E 15 S/16 S) for Timer
Connection of Micro-switch bl and b2 for Curve Switches
Battery Discharge Indicator up to 12/84
Battery Dimensions and Weights
Adjusting the Electronic System
Adjusting the zero Position of Travel switch U25
Adjusting the Travel Switch
Adjusting the Control Board U200
Measuring and Setting Drive Current FS
Testing and Setting Handbrake Current HBS
Setting Run-up Time HZ
Setting Braking Current RS
Settings for U200
Maintenance and Repair Instructions, Removal and Refitting of Essential Components 1
Testing of Carbon Brushes on Traction Motors and Hydraulic Pump Motors
Changing the Brushes on the Traction Motor
Changing the Brushes on Steering Pump Units
Changing the Brushes on the Hydraulic Pump Motor
Complete Removing and Relifting the Hydraulic
Pump Unit
Removing and Refitting the Steering Pump Unit
Replacing the Brake Linings
Replacing the Hydraulic Filter
Removing and Relifting
Complete Dismounting of the Motor with Wheel Drive
Fitting New Brake Disc
Removing the Motor from Wheel Drive and Refitting Renewing the Shaft Seal on the Drive End
Wheel Drive, Fitting, Pinion
Fitting the Motor onto the Transmission
Refitting the Wheel Drive with Electric Motor
Dismounting the steering Axle
Refitting the Steering Axle
Hydraulic Circuit Diagram E 12/15/15 S/16 S for
Working and Steering Hydraulics 1

Format: PDF, 78 pages
Language: English