Mazda MX-3 1992-1998 Workshop Repair & Service Manual
Complete digital official shop manual contains service, maintenance, and troubleshooting information for the Mazda MX-3 1992-1998. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100 complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.

This manual for Mazda MX-3 1992-1998 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.

EXCERPT:
1.8L V6 1992 MAZDA ENGINES 1.8L V6
ADJUSTMENTS
VALVE CLEARANCE ADJUSTMENT
1. No valve clearance adjustment is required, as hydraulic valve lash adjusters are used. If noise exists when engine is started, operate engine at 2000-3000 RPM for 10 minutes.
2. If noise stops, valve lash adjuster is operating correctly. If noise still exists, check engine oil level and oil pressure. Oil pressure should be within specification. See ENGINE LUBRICATION SYSTEM under ENGINE OILING. If oil pressure is not within specification, check for defective engine components.
3. If oil pressure is okay, remove valve cover. Push downward on valve lash adjuster. If valve lash adjuster pushes downward, replace valve lash adjuster. See VALVE LASH ADJUSTER under REMOVAL & INSTALLATION. If valve lash adjuster does not push downward, check for worn or damaged camshaft and components.
REMOVAL & INSTALLATION
FUEL PRESSURE RELEASE
1. Start engine. Push release buttons on each corner of rear seat lower cushion. Remove rear seat lower cushion. Disconnect fuel pump electrical connector, located on top of fuel tank.
2. Allow engine to idle until it stalls. Turn ignition off. Reconnect fuel pump electrical connector. Install rear seat lower cushion.
3. Before disconnecting any fuel line connections, cover connection with shop towel to absorb any residual gasoline that may remain in fuel line. Carefully loosen fuel line connection, allowing residual gasoline to be released.
COOLING SYSTEM BLEEDING
1. Fill radiator and coolant reservoir. Start engine and allow to idle until engine is at normal operating temperature and thermostat is open. Accelerate engine to 2200-2800 RPM for 5 minutes.
...