Suzuki Aerio/Liana 2001-2007 Workshop Repair Service Manual
Suzuki Aerio/Liana 2001-2007 Workshop Repair & Service Manual
Complete digital official shop manual contains service, maintenance, and troubleshooting information for the 2001-2007 Suzuki Aerio, Liana. Diagnostic and repair procedures are covered in great detail to repair, maintain, rebuild, refurbish or restore your vehicle like a professional mechanic in local service/repair workshop. This cost-effective quality manual is 100% complete and intact as should be without any missing pages. It is the same factory shop manual used by dealers that guaranteed to be fully functional to save your precious time.
This manual for 2001-2007 is divided into different sections. Each section covers a specific component or system and, in addition to the standard service procedures, includes disassembling, inspecting, and assembling instructions. A table of contents is placed at the beginning of each section. Pages are easily found by category, and each page is expandable for great detail. It is in the cross-platform PDF document format so that it works like a charm on all kinds of devices. You do not need to be skilled with a computer to use the manual.
YEAR: 2001 2002 2003 2004 2005 2006 2007
MODEL: Liana (aka Aerio) (RH413, RH414D, RH416, RH418 Series)
FORMAT: PDF (919 MB)
Aux. Emission Control Devices: 1B-4
Vacuum Tank Removal and Installation
1) Hoist vehicle.
2) Disconnect vacuum hoses (1) from vacuum tank (2).
3) Remove vacuum tank with its bracket (3) from drive shaft center bearing support (4).
4) Remove vacuum tank from its bracket.
For installation, reverse removal procedure noting the following.
• Tighten vacuum tank screw to specified torque.
Vacuum tank screw (a): 7 N·m (0.7 kgf-m, 5.0 lb-ft)
Vacuum Tank Inspection
1) Check for outside of vacuum tank visually.
2) Check vacuum passage of vacuum tank for clog and leaks as follows.
a) When applying vacuum to hose (1) using vacuum pump, vacuum is not maintained.
If vacuum is maintained, replace vacuum tank.
b) Plug nozzles (2) with finger.
c) When applying vacuum to hose (1), vacuum is maintained. If vacuum is not maintained, replace vacuum tank.
Vacuum Hose Inspection
Check hoses for connection, leakage, clog and deterioration. Replace as necessary.
EGR Valve Inspection
“EGR Valve and EGR Valve Pipe Removal and Installation in Section 1D”
1) Using vacuum pump, apply vacuum to diaphragm chamber.
Check EGR valve for operation. If check EGR valve does not operate as specified below, replace EGR valve.
EGR valve operation vacuum