There are some special components used in LCD monitor that are important for safety. These parts are marked on the schematic diagram and the replacement parts list. It is essential that these critical parts should be replaced with the manufacturers specified parts to prevent electric shock, fire or other hazard. Specifications, percautions, timing chart, operating instructions, wiring diagram, block diagram, description of block diagram, adjustment, troubleshooting guide, printed circuit board, exploded videw, replacement parts list, schematic diagram. Block Diagram descriptions: Video Controller Part & Display Data Transmitter Part.(MST9111)
This part amplifies the level of video signal for the digital conversion and converts from the analog video signal to the digital video signal using a pixel clock.

The pixel clock for each mode is generated by the PLL. Micom Part, Power Part, EMI components., Input rectifier and filter., Energy Transfer., Output rectifier and filter., Photo-Coupler isolation., Signal collection, When entering Service mode: You can check the OSD as described below by pressing down the power key and the menu key while the power is off.

Whenever you press the left/right key, the module applied to the current model will be displayed. When the module applied to the current set is displayed, turn the power on and off to execute all module settings. Adjusts the offset and gain values that are the basis of the color coordination value. The result differs according to the pattern and video card signal level. These two menus are not used separately but executed when the ADC CAL is executed.